Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
I meant NTK
It's a 2000 4.0 with federal emissions
I did check the wires on the sensor and didn't see any bad wires. Had the Jeep in start position to check for voltage/resistance. Didn't hit me to have the vehicle running to check for voltage and resistance
While the Jeep was on I did look...
I replaced the O2 sensors last spring with NGT sensors. The one that's coming Tuesday is Bosch. Napa can't guarantee a NGT coming in any time soon.
I checked the harness and it looked fine
Copy and paste from another XJ forum
Last night my CEL came on and went to scan the code. P0132 came up. Bank one sensor 1 upstream O2 sensor. I replaced that o2 sensor back in May
This morning, I noticed a rough idle along with the present code. I cleared the code to see if it would come...
Afternoon everyone.
To reply to the cleaning grounds. I have done that already. Cleaned the 2 studded grounds couple of days ago. I cleaned another ground yesterday in that same area close to the other 2 grounds
I went to Oreillys this morning to scan to see what codes appeared.
P0132 bank...
With testing the CPS and TCM through scaning. Do I have the Jeep in turned on mode or working gauges mode?
I did clean the 2 grounds on the block, by the A/C compressor. Are those the 2 grounds you are referring to?
Hello y'all. New here and wanting to see if any of you know what's up
About a month ago. i had some stalling/no pedal response. It happend for one day and never came back. No CEL
Then two weeks ago it happend again. Decided to replace TPS(Mopar) and CPS(NAPA), cleaned throttle body. The issue...