Recent content by penberth

Just wanted to let you all know that I got the old trackbar off without too much trouble. All I can say is that a Hi-Lift jack handle, PB Blaster, and a pickle fork were my best friends during this endevour. I got the new JKS bar today, and it went in without much trouble at all. From what I can...

Sorry, totally forgot to put that. It is a 2000 Cherokee Sport.

I think I popped the fuse for the cigarette lighter. So I went to look in the fuse box to see it was. Anyways on the backside of the little door covering the fuses, it says "See owners manual for fuse locations, etc." So I pulled out my owners manual, looked at fuses (p 193), and it says, "See...

Ok, I got a little farther today with this issue. I did some more digging, and found that my track bar does have play in it. It is on the suspension end, not the frame end. I was going to take it off today and check out the bushing, but couldn't get the bolt free. After trying for a little bit...

I am making some progress. For me, I have checked a lot of the parts that people are talking about on here. From what I can tell, all my suspension components are tight and in spec. A buddy of mine that was a Ford technician drove my truck the other day and he had two ideas. One was the ball...

Hey Tommy, thanks for helping me out. When I jacked up the tire, I was rotating it by the wheel. They were moving at exactly the same time. So I think I am ok there. As for tire rotation, I haven't rotated them yet, but have traveled less than 2000 miles since I got them. I got the alignment at...

So I unbolted my skid plate, and started looking around. From what I can tell: - Ball joints are fine. -Track bar ends are fine. Both sides are tight. -Steering shaft has no play, and when turned, it turns the gear. Other side of this, the pitman arm turns as expected with no delay. -Steering...

Some people on this list might remember my steering box breaking from the frame. Happened over a year ago now. Anyways, ever since this happened, the steering has not be right. It seems sloppy / loose / dead at the center. For instance, I can be driving down a straight road, and can move the...

I hope this is the right place for this post. Anyways, I've already sent off a letter. I hope others will too. This is not good news. If it passes in NY, other states may try to pass it too.

Just wanted to pass this along as I know lots of Jeepers have ARB bars, etc... I got this from a local Jeep club in Buffalo, NY.... Links: http://www.semasan.com/main/main.aspx?id=62090 http://www.autoblog.com/2006/03/28/...-brush-bar-ban/ URGENT LEGISLATIVE ALERT New York Introduces Bill to...

I was just wondering how you know this, or where did you find this out? Reason I am asking is that I have OME 934 (ZJ V8 coils) on my XJ now with .75" spacers. I am looking to go taller, and my guy recommended OME939 coils (TJ 4" coils). Will I get 4" of lift, or will I end up with 3" of lift...

Sold.

It is on the verge of being sold. I will let you know if it falls through.

It would definitely fit a 1997. The front receiver would have to go, which is no biggy since you won't need it anymore anyways. You could sell it and make back some cash. As for the tow hooks, I am not too sure. I had the Jeep factory hooks, and they mounted up fine, but the one brace wouldn't...

Hey Maximus! Can you clean out your PM box? Or email me at penberth @ Niagara4x4.com