Recent content by MikeT4

Thanks for your reply

So I don't have to haul a whole tool box into the J/Y does anyone know what size the speed nuts are that hold the heat shield in place.

Thanks I am off to the J/Y

What year Cherokees came with a Heat shield attached to the under side of the floor above the muffler? My 96 doesn't have one and I am in hopes of finding one at the J/Y.

I have used this trick and it works. First removing the long piece of broken axle shaft from the axle housing. Second take three stick welding rods and weld or fuse them together end to end. Then slide a rubber hose over the length of the three welding rods with one end exposed about 1/2 inch...

Thanks for your reply.

Can anyone tell me if the doors on a 2 door Cherokee XJ are the same from 1987 thru 1996? I need to replace the passenger side door on my 1996 / 2 door Cherokee XJ sport.

I would like to send you a PM but you PM box is full. Could you send me a PM so I might have a way to contact you. Thanks MikeT

I am in the process of upgrading my cables also but I have one question. I have a 117 amp alternator what size AMG fuse should I use?

Bump

Yep your right good call. I added mine just above the tire and below the CB antenna mount , it is hard to see in the picture. You can see the wires for the brake light and the coax in the view from the back side.

Yes here is mine with a 31 on it and I have seen them with 33 also. I also found mine in a J/Y and installed it on my 96. I added a loop for my CB antena as you can see. Be sure to get everything as suggested and take measurements for the hole locations on the quarter panel mount. Good luck

When I first installed my Aussie locker in my 8.25 I had the same situation loud clunky while turning. They call it ratcheting but it is actually a clunking sound. When I would go into town and turn a corner everybody would look at me like I just fired a shot. After time it was quieter and I got...

Make sure you get the complete rear bumper and all the support brackets. There are two brackets one on the inside or the body mount and one on the underside of the bumper on the passenger side. It is a good idea also to take measurements on the body mount location so you can duplicate where to...

I found that if the engine is warmed up the bolt is easier to get out. When it is cold it is a bit---------.