Recent content by Mark817XJ

$200 OBO no bell housing. Pulled from a running driving 1995 cherokee, 23 spline output. Will fit 95+ cherokees.

If I don't I have access to them, what are you looking for?

Yea the SYE needs to be in but if you buy the SYE in from him he will incorporate the dimensions of it into your stock numbers. I wouldn't be able to meet you during the week but next Sunday I can meet you. Saturday I have prior arrangements. Give me a call during the week.

Sure, at your expense. I'll PM you details.

I'll have to get the casting number but I don't want to unwrap it. I know for sure it is a 1992 block but it is not an H.O. Non-HO = renix doesn't it? Either way, it is a 92 non ho. If anyone is serious I'll go get a picture of the casting number.

I have parts from my stroker build I lost interest in for sale. Block: 1992 Renix, bored .030" over. Deck and alignment were checked and no correction was necessary. New cam bearings and freeze plugs were installed and it was pressure tested, magnifluxed and hot tanked. The machine work was...

Hey Roger, haven't heard from you in a bit, everything going ok? I like the Tom woods SYE, little more costly than the rest but a better product in my opinion. If you call tom and tell him what you want he will walk you through taking the measurements and build it for you. It will fit, he...

I have one out of a 1995 XJ, ran and drove just fine when it was pulled. We pulled it after the jeep was rolled. No bell housing but otherwise it is 100%. I'm in Fort Worth. Name your price.

Come get this shit out of my garage. I've asked you this once before and you gave me an excuse that you blew up all the motors you own. I've nicely asked what went wrong or what I can do to help. You said you'd call and explain, you have no vehicles and only work 40 hours a week, make time to...

Evan, What went wrong with your motor? Before you go off and sell everything you know you have that rebuilt at city motor supply cheap right? Less than $500 for a short block and like a 2 day turn around.

That's good, maybe we can still use the warranty then..

Actual I just found the problem. I would have argued that we could not have installed the wrong model number locker but it appear we have. I compared a brand new XJ Dana 44 Aussie with what we just took out of Rogers and the side gears are identical in every way but the center gears are...

I just got back from Rogers and the pictures actually make it look worse than it was. We pulled it all apart but measured it first. Gear backlash was at .018" and pinion bearing pre-load was at 2in-lbs. The gear pattern shows the pinion being to shallow. When I originally setup the gears I...

I will measure and picture axial run out, back lash, gear pattern and verify torque on everything, assuming all are fine what do yall think?

Hey Rodger, glad to see the pics finally. You can still see gear marking compound on the gears.. I'd like to measure backlash and run a pattern on the gears before we take it apart any further. I would love for someone to chime in, I installed the gears and locker for Roger; everything went...