Recent content by LOOKSURF

No not unless you are willing to pay the $500.00

29 spline

have a 8.25 with 4.56 gears and ARB locker for sale. $500.00. Buyer pays shipping or you can pick up in Kansas City. This direct swap for cherokee. Will consider trading for 35" MTR's Manik front brush guard for Cherokee $125.00

I got the JP magazine and in it it says the The HP Dana 30 came stock in XJ from 84-97 1/2. What came in the 98-01 models was it a LP Dana 30?

Stupid question but I want to make sure I am doing it right. I take the the bevel square and place it on my diff bolts top and bottom on the passenger side and them make sure the square is level horizontally and take the reading and it should read -86 degrees on the protractor.

So if I am reading your site correctly I check caster by using a bevel square ( adjustable square ) with a level on it against the diff cover bolt heads that are above and below the axle or use the flat round area next to this. Then I set a protractor on the square and I should read 87.5...

I have checked the joints they all seem to be fine. What should be pinion angle be with a 4 1/2" lift? Would I make my upper control artms longer or should I go shorter?

I had front end alignment done and my front driveshaft was not instlled when I did this. Now after installing the front driveshaft I now get vibes that start about 60mph what do I do to correct this. I upper and lower adjustable control arms. This on a 98 XJ with Dana 30 4.56 gears and the RE 4...

Does anyone know if the RE Superflex NON adjustable rear lower control arm on a TJ will fit a 98 XJ. I know the adjustable control arm will but I am not sure about the Non adjustable one.

My wifes 98 XJ has 4 1/2" Rubicon Express lift we just installed and I was wondering if I could get my 33" tires off my TJ to fit since I am going to 35" tires. What would I need to do to get them to fit?

Can you tell me where the idle air control motor is located and what it looks like?

Does anyone have any idea what I should be looking at so I can get the check engine light off?

How much for the carpet shipped to 64057?

What are ACOS? Also are you going to go ahead and get your CV made now are wait until the lift is installed and then get the measurements? Tom Wood's say they can make the CV for me now and they just need to know what lift I am going with and what size my u-jonts and the current measurements...

This same thing I just ordered this week. I also got the 3/4" spacer up front so the jeep will sit level.