Recent content by jeffreylane

sold Sent from my SM-G930P using Tapatalk

sold. Sent from my SM-G930P using Tapatalk

Sold. Thanks! Sent from my SM-G930P using Tapatalk

responded. Thanks. Sent from my SM-G930P using Tapatalk

cool. Just send me a text or msg when you know you are headed this way and see if I still have them. Sent from my SM-G930P using Tapatalk

ORFab rear quarter panel armor for jeep xj. Wheel opening has been opened up some (cut) as they were originally on a stretched xj. You can see in the pictures how they look on a non stretched xj, as that is what they were on last. There are some grinder marks by some of the bolts that you can...

Used Rough Country Jeep XJ rear shackle relocation kit. Fits 84-01 Cherokee. I can get you pictures if interested. $50. Located in Memphis, TN. 901.270.3364 Sent from my SM-G930P using Tapatalk

Used Rough Country Jeep XJ long arm kit. Fits 84-01 Cherokee.* Includes Lower control arms, upper control arms, crossmember with side brackets, and transfer case skid. Does not include hardware, as most of the bolts were crudded up when I took the kit off. Good condition. $325. Located in...

I did test all the sensors before changing anything. I also hate to parts shotgunned without testung I am just running out of options. The TPS was originally out of range, being at about 70% at idle. After replacemant, the voltages and curve all look correct. I have also run new wiring to all...

When you say temp, are you talking about water temp or IAT? The water temp hand on the dash seems to function ok, if that means anything. Sent from my SM-G930P using Tapatalk

I did swap the map sensor out with 0 change. It tested good with a meter, but swapped it anyways out of frustration. No change at all. So far, other than the codes, the only thing not testing out as normal is the erratic fuel pressure gauge. Sent from my SM-G930P using Tapatalk

Thanks. Trying to avoid scrapping it. It's a pretty decent XJ that was a daily driver up to this problem. It will hurt to not figure it out and have to scrap it. It is long armed, locked, geared, etc etc. Sent from my SM-G930P using Tapatalk

I still get the TPS ober/under codes, but TPS seems to check out fine with a meter. Smooth electrical curve. Sitting about 17% at idle. Unplugging o2 sensor causes no change either. Is the O2 sensor info being used on cold starts, or inly after it is up to operating temp? I have looked over the...

Thanks for the replies. Would o2 aensor and temp sensor come into play on a cold crank? My understanding was that it ran in closed loop until it was up to operating temp, then used the info from the o2 sensor. I may be wrong on this though. Both tested out fine with a meter. I went cheap on...

Forst off, thanks for taking time to read this. I have read around the forum for quite some time now, but like most forums I read, I don't really post much. Warning, this is a long post, but I don't want to waste anyones time being redundant an things that I habe already tried.. I have a...