Recent content by J-MAKSXJ

Thanks Matthew, I was at a loss on how to remove the locking plate I will let you know how it turns out. Jim

I have removed my steering wheel to try and replace my winshield wiper, indacator switch as my broke off. I recieved a used module and lever. How do I remove the colum cover to access this part, it seems to be one solid unit, do I need to remove the ignition piece if so how?. any suggestions...

I have 90XJ 6" lift, tried to get it aligned today but the shop refused because they said my pitman arm angle was to steep ( it is a stock setup) is this a shop being to afraid to work on a modified vehichle or do they have a point your thoughts would be much appreciated Jim

Same thing happend to me, and all boiled down to the ignition control module under the coil, it was no good, went to junk yard got new coil and module and all is fine now.You have to watch though I had my coil tested at NAPA and it tested fine so I ruled that out for a while, then it was...

I have a 1990 XJ 4.0 5 speed manual trans all stock been topping up my Clutch fluid for 2 days now, noticed fluid on ground crawled under hoping to find that my rear main seal went again, but instead found clutch fluid leaking from bottom of bell housing, master cylinder ? is this external or...