Recent content by heavyhopper

now after removing diff cover is there a c clip or something to remove?

i know its been asked a million times before, but alot of the responses are different, so here it is dana30, u joints are shot, they have never been done to my knowledge its a 92 with 220kms, start to finish what is the best procedure, do i have to pull axles shafts, or can the u-joint be...

thanks guys

have a 92 xj has pro comp 3" coils up front and pro comp 3.5" leafs, what should i use to level this out as the rear sits a little higher then front, so should i go coil spacers up front with the pro comp springs? my rear height from ground to flare is 37" and front doing same is 35-35.5", thanks

no well i just finished building jeep and today was the first time i actually drove it since buying it about a year ago, im gonna do the thermostat tommorow, thanks

93 xj, 5spd with air, jeep doesnt want to heat up at all or very little gauge barely moves very little heat out of heater, im thinking thermostat anyone else have opinions on this thanks

i wont go any bigger then the 32/11.5/15's, i guess im looking for opinions on how the 15x7's will look compared to the 15x8's with the offsets?

can get a set of steel wheels 15x7 with a aprox 3.25-3.5" backspacing, question is iam gonna run for now a 31/10.5/15 mudder, but may move into a 32/11.5/15, will this rim work good? i had ar767 15x8 with 4" backspacing and liked the look of that offset, will this be close or totally different...

what valve?

on 92 xj, first is i am getting a good amount of oil in my air filter box, i know it coming from the tube that comes from the front of the valve cover, its soaking air filters. next is if i have to do the rear main seal is there an article on how to do it? thanks