• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Recent content by Green XJ Jeep

  1. G

    Anyone alive here

    Seems that when they did the revamp it kind of died off and as the years go by there are less and less xj's
  2. G

    If I can fit a ZJ fuel tank, anyone can (lots of accesssories)

    No the ZJ tank swap is for 97 up. What you can do is modify the vent in the tank to get full capacity. http://gojeep.willyshotrod.com/HowtoFuelTank.htm
  3. G

    Disc swap?

    You shouldn't have that much of a difference in pedal travel if the system is properly bled. My guess is you either you still have air in the system or you have air getting into the system. On mine I honestly don't even thing there is an inch difference in travel between drum and disc. I did not...
  4. G

    Fan clutch re-hash......

    I didn't like the ZJ fan clutch. Robbed to much and gas mileage with no appreciable difference in cooling.
  5. G

    Battery opinions

    https://www.youtube.com/watch?v=q5zLxD74r20
  6. G

    Please try this with your XJ and tell me results?

    Doesn't take much rpm to increase line pressure enough to cause this. The reason it clunks going into drive/reverse after a pause in neutral is the increase in torque converter speed causing a higher fluid pressure. Chances are however that the previous owner installed a shift kit. Which...
  7. G

    Been awhile!

    https://www.napierprecisionproducts.com/
  8. G

    AC clutch bearing must be bad...options?

    That should fit a 91
  9. G

    What do you run your 31's at? What do you air down to?

    Depends on the tire. My gooodyears I run 35 On my mt2's I un 23, anything more and the ride is terrible.
  10. G

    Regearing for dummies

    Amazing what a little bit of life experience will give you isn't it?
  11. G

    Oil filter adapter/ pan gasket replacement

    That wrench wont work unless you jack the motor up. I used a stubby torx that I could put a wrench on. I think it was https://www.amazon.com/Z-Red-T1000-Torx-Bit/dp/B009PJPFB6 For the oil rings I tried the local autoparts store ones and within the week I ended up replacing them with Mopar#...
  12. G

    ZJ fan blade upgrade?

    It also has less slippage built into it. Dont emember the fact percentage but it is noticeable. I personally didnt like it. Made more noise with a noticeable decrease in mileage without much improvement in cooling. I recommend the op service their cooling system first before you start throwing...
  13. G

    front brakes sticking

    I didn't. I just used enough heat and wire speed (flux core) to make sure I wasn't making things worse then ground it smooth
  14. G

    2000 jeep cherokee rebuilt 4.0 with cam, Low Vacuum at idle

    That cam is fine for fuel injection. I pull over 19hg at idle with the same cam in my 96
Back
Top