Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
Re: Northwest Karma 2015
**Correction* The MJ bench back rest seat is the black vinyl.
I also have D44 drum brakes. Drums, spring kit, and a good set of brake pads.
Re: Northwest Karma 2015
-2002 WJ D44A rear axle. Mostly good for scrap
-96-97ish short block. It melted #1&2 pistons but I have the entire motor already dissembled. I will just not have the time and $$ to rebuild and install in my MJ with baby on way.
-A tote or 2 of various spare parts for...
So while poking around the Jeep I notice that the voltage that is backfeeding into my 02 heater wire happens to be the same voltage that is powering the relay coil. ~10.5volts or so. I also disconnected a large plug next to the relays and surprise the voltage goes away. i reconnect it and it...
I was idling in driveway a while. Will have to check that my aux fan is working. There are 2 vac readings as combined will equal atmosphere 30.1 I believe. Will have to look at manual to see which one is manifold vacuum.
I meant new throttle body gasket.
-I installed a new TPS gasket.
-Crankcase vent is recently replaced with it working properly and no clog.
-Spark plugs new, entire distributor is new, brass all the things, new plug wires. also did Cruiser54 tip of advancing the timing by modifying the distributor.
-IAC has been clean for a...
O2 voltage fluctuates up and down. the exhuast cycles between roch and lean. also the fuel sync shows +/-. So seems everything is working on that end. I also have no o2 relay plugged in right now as it seems I have a short somewhere but it isnt hurting me. I am worried that at idle my...
Here are the pictures. After a couple of trips it seems the computer is learning to lean out the fuel mixture in the LT trim. starts at 128. <128 means lean and >128 means rich. so i do noticed the ST_trim (short term) wants to be very lean at idle telling me I am running quite rich at idle...
I will make a full reply tomorrow when I can upload pics of the mt2500 outputs. Seems I have 15" of vacuum and even with no o2 relay installed it works just fine at idle. I adjusted my tips from 16 to 17% on the mark and replaced my b+ latch relay today. Seems the 1% did make a noticeable...
Typical remix low idle rough running troubles.
A weird problem I found out with my O2 sensor. Unplugged it runs the same, removing the relay it runs the same. The odd part is using a multimeter I can tell it gets good power on 30. The ground is good. And even gets a clean signal to turn off...
haha, I just got around to looking for this post. So glad you were able to help me get this truck fixed up. I ended up lowering the front a bit as well to give me the look/ride quality I am looking for in my DD. I'll have to snap a few current photos. Nothing spectacular for this rig. Just...