Recent content by diluted1

Nah man, I have a 17 mo. old daughter and can't ride like I used to anymore.

Bad ass helmet, and good price, I had one just like it!

Ill sell you my canon 5d with ultra II 4 gig card and 24-105 L lens for 2900.00 Nah, thats my baby, but we have the Sony cybershot, and it takes a better picture than the canon IMO.

pass/driver door?

sweet... thanks bro!

I have the 6.5 packs, and I netted about 7.5-8 at first, but take the last spring out, it will make it softer and give it a month or two and it will calm down. Dont overtorque the shackle bolts.

Off topic, but Goatman, do you have a buildthread or and specs/pics of your new xj buggy build?

Hey guys, just FYI http://www.pirate4x4.com/forum/showthread.php?t=583812 He is a stand up guy, very fair on price and a lot of good parts. I talked to him for like an hour on the phone. The lift, steering and syn line are gone I know of. I am pending the air shox.

Ok,.. I have a few things for sale... Late 70's Ford HD HP44 Complete (backing plates rusted out) 200.00 75ish Ford LP 44 w/ the big 60 hubs (good for knuckle out) 75.00 same era rear D60 w/ I believe 4.10 and factory trac-loc 75.00 (non-matching) Ford T-18...

ahhh.. I gotya bro, sorry about that! I guess I didnt look hard enough!! --Jason

Jeepfreak- Thanks, that was what I was thinking... so just plasma a "slot" and slide a nutplate in you think? 98xj_87- Conway, about 15 minutes north of north myrtle beach.. Oh,.. while you're on the thread, how liberal are the inspection stations down there? I move june 15 and need to start...

Plating/sleeving the frame is the first thing I am going to do and I get that. I guess I wasn't clear enough. If I were to do this and wanted to basically have a flat belly, I was wondering how everyone was bolting they're custom crossmembers to the new sleeved frame. Make any sense? Are they...

Hey,... Wondering what you guys do for attaching your own crossmember, rear link member? Do you make "nut plates," cut open the frame and throw them in, or maybe integrate the "nut plate" into the stiffeners when you tack them up? I am just curious to what everyone is doing, as I will be...

I would fold it...

Like a parts breakdown bro? You need to know how it goes back together?