Recent content by deezyperformance

Thanks guys looks like I'll be taking a look at the NSS this weekend. As far as the ignition switch actuator was it just a mater of cleaning it or did you just replace?

It doesn't turn over at all and she said it makes no audible noise. Nothing but dash lights. 2nd or third try it fires right up.

98XJ 4.0 on occasion will not turn over. It's very intermittent, dash lights up like all is good but will not crank. Was doing it fairly often so a put a new starter in it and it seemed to clear up. It's done it a few times again now and looking around everything I can find with similar...

Fluid was dark with 191,000 miles since this has happen I've done two flushes 4qt at a time with no difference. I suppose sitting at an angle that long did something?

Got an 89' started with very weak reverse then to no reverse, it feels like it engages but thats about it. Worked completly fine until it had been sitting with the front on jack stands for about 3 weeks.:doh: Just did some general stuff valve cover, wires, plugs etc. Also completly replaced the...

If your willing to drive I've got 31" BFG A/T on unlimited rims 31" Cooper STT's on stock steelies 30" Firestone Muds Could get em as close a Des Moines

I was thinking about swapping the axles from a 96 to my 89 I can get the pair for about what It would cost to just put new shafts with the larger joints in my current 30. Can I assume that it has the larger joints and a 29 spline 8.25 as long as it doesn't have ABS. Is there anything else I...

Wishfull thinking on the swaybar, fingers are crossed that my bumper gets here soon. hopefully plenty off bunny trails up their for me.

Hey everyone been lurking around this place here and there for awhile and I figure I should wheel this thing once. But I'm worried about tech, I don't have a CB and my "tow points" would be a Class II hitch and front sway bar, any thoughts? Oh yeah saggy springs, open diffs, and 30" MTs but I...

So i'm changing valve cover gasket and filter adapter o-rings anything else I should do while i'm at it? How does the top end look good or bad I don't know what to look for. ">

Which would be best? http://www.sears.com/shc/s/p_10153_12605_00952155000P?vName=Tools&keyword=bolt+extracter or http://www.sears.com/shc/s/p_10153_12605_00966202000P?vName=Tools&keyword=bolt+extracter Or if it comes to it I do have some self taping laying around.

I'll get it on here soon just have to find time between work and the baby. I just got it last fall and it was to damn cold to do anything this winter so that was the filter that was on it I usually use purolators.

pm sent

Yea I was kinda disappionted when I found out it had no wood grain, now It's blue/silver with a tan interior. I've always liked the look of the waggys. I left him with an offer but he had just put if up so we'll see, although I'm not exactly sure I need the parts jeep with 325k and a wood...

yes X2 ">