Recent content by DaYeep

Looks nice! Thanks for updating the post.

Very nice!

Thanks! You can do the same or something similar. Just measure twice and cut once. And remember, not much you can't fix with a welder and a grinder.

Great write up and VERY nice work! I finished a partial lower exo-cage on mine a couple of months ago for the Chile Challenge in New Mexico. I wanted something much different than everything else I have seen. I copied the front from a rock buggy called Bounty Hunter. There wasn't a corner I...

I did mine a little over 2 years ago. I chose to use 2 x 5 x 1/4 rect. tubing, as I didn't want it sticking out as much since I was adding some round tubing to the outside of it, for side clearance. I think I used 1-1/2 x 3/16 square for the frame supports on the back side. I don't have a...

My wife and kids bought me this set for Christmas, along with Ball Joints. I destroyed my last set at the Chile Challenge in October. What a nice surprise! This was a great price, exceptional packaging and quality parts. I will definitely buy from RWK Haus again! :yelclap:

I too have a vertical gottrikes. Works great, no issues. Really like that I can move it around and bend where I want.

I have been running 35's on a 7" lift for about 6 years, wheeling pretty hard all over AZ. I to have replaced nearly every joint/bar/rod combination you could think of, including the steering shaft 2 times so far. Not to hard to change. You can buy new, or pull a part. There is a rubber...

Took back the NAPA ZJ cables and ordered the ones from ECGS.

I would like to jump in this post if I may. About 4 years ago I did the 8.8 swap and installed a drum and Lincoln locked it. Loved it and wheeled 3 sets of tires off of it in tough Arizona terrain. I have upgraded and just swapped in a disc 8.8 with limited slip (I want to go back to mall...

Re: Re: 8.8 Swap Shock Mount Questions. My mounts are above the bottom of the axle tube. Put it on a ramp when you are done and measure your max compression & extension and order a shock to fit. I've wheeled mine harder than most with no issues.

Very cool....I'm gonna make one!

Question for the GotTrykes owners: once complete with 1 die set, how much do you have in it, excluding labor? I think I'm gonna do this too, just planning a budget. Thanks!

Re: New Project... wife says it is ugly :( Looking great Glenn!

...and he's able to post on NAXJA because?