Recent content by BrianE

Thanks for the input, I think the ECU obd2 system is the same for you 96 versus my 99 so I should not have huge issues. Mild port work on head, port match, un shadow the exhaust valves which will lower comp as well. working on relieving the dead quench area now. I want a basic daily driver and...

I know this is an older post but how does your engine run with the 4529230? Any computer issues or hiccups through the rpm range? I found a couple new ones, trying to decide between that and the 28 or 29.

Just a little cation to all TITAN sells on eBay under a few different names! Either way they SUCK!

This was my main question, if the engines with dist run as good as the COP. This 00 will blister the tires from a dead stop, my 99 sure didn't. "same gear ratio and tire size" Heads dont bother me I have a garage full of them. I just like how smooth this 00 runs compared to my other Jeeps. my 93...

I just hope the earlier style ignition runs as good as the COP does, that's my biggest obstacle. I can fix the rest. I also have to figure out why every XJ I ever saw has water under the rear seat, especially when they haven't left the yard in a month. From what I head the 0331 usually are ok if...

Single cat, Tampa Jeep bought new there. Yea the head is good, but I have plenty of 0630 and the older 71?? "can't remember numbers anymore" LOL heads. The 00 is 2x4 so no front axle. The frame is good but the passenger doors and the center pillar are quite cozy with the seats and will need a...

I bought a 99 that had a slight engine noise which is now much worse:) Tore it down and the crank was not savable, to bad since the motor is spotless inside 116,000mi. Anyways picked up a wrecked 2000 2x4 and was going to yank the motor because it runs so d#m good. But since its the COP motor...

I know what your saying but their lift measurements don't add up either. I think they did the lift spec with a 1.5 ratio rocker instead of a 1.6. I measure three lobes and multiplied and came up with 433 lift. It ran good in my stroker a little lazy off idle but I had gears and a stick so it...

I was just asking because I have had it on the shelf for 4 years. Has about 500 miles on it. Looks new, I had it in a JUNK TITAN STOKER I bought back when no one knew about their products. I am doing a build for a basic street stock 4.0 and trying to go WAY low budget since I bought this Jeep...

Anyone here try or use the Elgin E-1122-P Cam in a 4.0 build with FI?