Recent content by birdmanxj

its a 95 cherokee country 4.0, replaced alt a/c pullie swaped fan pullies. you can see that the belt is shearding on the outer edge like its getting pulled out. Owner said balencer was replaced before. could it have walked out or replaced with the wrong part? are there any other common causes...

it had some autozone replacment seloniods in it which look different then oem.I replaced it with the ones from the link and it now shifts fine

I am getting code po301 which is clynder one missfire. new plugs wires cap rotor, tps, and injector. it has a random slight hesitation under light acceleration but does not happen often. I only notice a slight miss when at idle. what should I check next. thanks

and its a 97 xj.

I bought these http://www.transmissionpartsusa.com/...-00094393a.htm. I found the link on here http://www.naxja.org/forum/showthread.php?t=996259 these look diferent want to make sure they will work before I take it apart thanks

I just test the seloniods at the tcu, seloniod A is 2.7, B is 8.5 and the lock up is 8.5 I had my meter on 200ohm,s.

just did a tps test on my 97 xj, I am showing 5.12 volts at idle and 5.11 at wot. is this bad??

doea anyone have a TCU wiring diagram for a 1997 xj. I need to test my seleniods and can only find a TCU diagram for a older xj. thanks

does anyone have the link with a 97+ tcm diagram??

is po753 for the lock up soleniod? do i need just that one?

1995 cherokee nothing on the hvac works. I have checked the fuses, the blower fuse was blown I replaced it and still nothing. jumped the blower motor to the bat and it runs. I pulled the hvac control out there is a little rust around some of the wires. I pulled the blower motor resistor out it...

97 xj with aw4 trans. it skips 2nd and goes to 3rd and does not downshift. the codes are po700 and po753. how do i check the seliniods and could it just be the tcu. What else should I check?

with the tcu unpluged I have 1st in 1-2 3rd in 3rd 4th in drive. with it in it shifts 1st to 3rd at high rpm and somtimes does not downshift. so far this is what I have done trans flush new filter gasket and soliniods rebuilt saftey switch/adjusted adjusted the thortlle cable tps sensor is...

Do i need another tcu from a 97 or can I use one from a newer model? thanks

think I'm going to try a new tcu. what year model tcu do i need? will anyone from 97 up work? or all they all the same i have one from a 95 i could try are they the same