Recent content by Biggie Z

I figured it out by using a picture in this thread: https://www.cherokeeforum.com/f2/overhead-console-wiring-question-197068/ Pin 1 - +12V Pin 3 - Lock Pin 4 - Unlock Pin 10 - Ground I don't know what any of the other pins do, I'm assuming lights, horns, alarms, etc. The only reason I wanted...

Or if anyone has a 93-96 FSM, is there any info on the pinout for the IR reciever?

If someone has a 93-95 XJ with overhead keyless entry, can you please take a look at the wiring that goes into your receiver. All I need to know is what pin the pink, black, pink/purple, and orange/purple wires go into. Also a picture of the harness from both sides will work. Thank you.

Thank you, this was very helpful, in that case I will attempt to wire in the IR receiver that came with the key fob, but the connectors are different. I already figured out which wires on the harness are for + (pink), - (black), lock (orange/purple), and unlock (pink/purple) using the Hayes...

This is why I thought it would work, Rob, do you know if the 91 IR remote is different than the 96? I was under the impression they all used the IR remote Mopar part #56009031. Does anyone know the wire colors for the 91 IR receiver module wiring harness?

If anyone has a 91 owner's manual can you please check and see if there are any key fob programming instructions. This would be much appreciated.

Thanks for all the replies, I came across a factory IR fob on ebay for much cheaper than most currently listed so I thought I would give it a shot. It also came with another receiver unit which has a different wiring harness. Anyway the programming instructions I found online aren't working so...

I have have a 1991 XJ with factory keyless entry wiring and IR dome but no remote for it. I was searching for a replacement but all the ones listed for sale are advertised for 1993-1996 (Mopar part #56009031). These jeeps seem to have the same IR keyless entry dome on the roof console as my 91...

Thanks for the info everyone, VAhasnoWAVES, is there any way of telling the coil spring rate by measuring the diameter of the coils with a caliper? I can't find any info on the lift kit on the zone website, I think it's an older model.

I recently bought a new XJ (wanted a 5-speed) and it came with a Zone 3" lift kit installed. The suspension is VERY stiff and the ride quality is pretty rough on the freeway and country roads. Can anyone recommend good shocks for a 3" lift. I don't use it for super hardcore offroading, just 4x4...

Hello everyone, I'm having a weird electrical problem with my jeep. When I turn the steering wheel all the way to the right, the ignition buzzer and interior lights turn on. It only happens when turning to the right, not the left. Does anyone know what the problem might be? Also, I could could...

Hello all, I'm moving from Sacramento, CA to El Paso, TX (about 1200 miles) with my XJ towing a 5x8 uhaul trailer. It's a 4.0L 5-speed and has about 196k miles. I would like a few suggestions on what I should have serviced in preparation for the move. I already got the engine/tranny oil changed...