Recent content by AirForce_XJ

Good thing i didnt find it sooner, had a reason to buy new parts without getting yelled at by the Wife. :laugh:

PigpenOp4 xbox CoD or BF3

I think i like your idea better. I have the cloth to put on a bare headliner. Unless you are willing to hold onto it until late july when i drive down to Florida.

Anybody got a headliner they are trying to get rid of? My lovely coworkers tossed mine in the trash while i was deployed. My fault for leaving it in the garage at work. Tired of looking at metal and wires. :eyes:

Check your IAC, if it hasnt been changed or at the minimum cleaned off in a while that may be the cause.

ITS NOT A TUMOR!!:laugh:

Re looked at the plug wires.......they weren't set all the way over the plug, causing it to arc to the valve cover. Go figure.

So here is where I am, new dist, cap, rotor, plugs, plug wires, put stock exhaust back on minus cat, still getting the stumble, in all gears.

Having the same issue in my 95 (AW4) just put a new TPS in her about two months ago. Didnt start happening again till i put a new (after market) muffler on.

Gray, but I'm changing it out for mossy oak.

I would but there isn't anything there! Just bare metal. I had all the stuff to do it, left the stripped headliner at work in our garage while deployed. 7 months later I get back and they had thrown it away about a week before my return.

Aligned my DS door, put general stuff back together that I had been sitting on for a few weeks now. Searched the web for a new headliner! They are a pain to find.

Bumping this up, old but I'll check into the info. Work on Pope AAF and if they have one might save me some money.

I just got back to NC after bein gone for 7 months and was only here for 4 before I deployed. Trying to find out the good spots. We had a pick and pull 5 min up the road in California. Thanks for the info guys! :peace:

Looking to do an LKQ trip to Durham, is it worth the trip? Just need a few small parts nothing major, mostly electrical crap for the door and heater blower control.