Recent content by 96crow

I have new caps ordered. I tried to post a picture but I couldnt. On the board, on the middle 100uf cap to the right of the small surface mount caps, I noticed that one time when it powered on the trace going to the left side of this cap glowed and smoked momentarily before the unit powered on.

Update II:So what i found was that pin 2 on the regulator is 4.76v. When power is put to the unit the voltage at this pin is about 2v then it slowly rises to ~4.76v. After it hits 3.09v the unit will power up but voltage will slowly rise to top out about 4.76v. The unit powers on fine its just...

Update: I was sitting in the Jeep preparing to write down some info. I turned the key on and let it sit for about 5 minutes. All of a sudden the module powered on without me having to manually reset.

This thread is fantastic. I have been working in my overhead console install in my 96 today. I am having somewhat of an issue. When I power on the unit, I can see red lines in the display. But the unit will not come on. As I was running some quick voltage checks I found that if pin 4 on the...