Get out there in you PJ's and get that sucker put back together.
Haha mine or Justin's? I need money to work on mine. Those PJ pants are so comfy I'm wearing them under my work clothes.
Get out there in you PJ's and get that sucker put back together.
Before Winterfest needs:
Oil Pan
Figure out why the rear D44 keeps blowing axle seals.
Figure out vibration above 60mph
Before Crawl and maybe some before Winterfest:
Rear bumper/tire carrier/hitch combo
Belly up skid plate
After market control arms/poss long arms
Rear locker - selectable
Full exhaust and header set up.
Spare D44 shafts (might be the fix for the leaking rear axle seal)
SYE
spare front and rear driveshafts
mac 'need to clean my white board off from KOH 2011' gyvr
Made a new list:
Reinforce sliders
Replace shock
Build front Bumper
Install winch
Check brakes
Paint front end
Swap transmission
Rewire rock lights
Add some speakers
Limit straps
Build rear bumper
Remove Reese hitch
Fix power steering whine
Find 97+ grille
New battery
Check cooling system
Wire e-fan to toggle switch
Have tire vulcanized
Check gear oil
:/ Sure wish I had more time to work on stuff.
Help Tim and Nick with what ever they need if they need it.....
My heep!
Starter
Compression check...
Fix drivers seat.
Find spare front DS or buy one....
Fix brakes, they work but could work better.
Dream list:
knuckles for the 60
35 spline outers for the 60
coil overs front? Jury still out on this one.
chop rear and 4 link with 4 suspension seats... jury still out here too...
Don't worry Andy, there is always next year....:laugh:
My list has to be done by WinterFest, but I'm sure I'll add more before the Crawl.
Install 8.8/4.5" leafs.
Install winch bumper.
Install/plumb MM hydro winch.
Install roof sliders.
Purchase and install rock rails.
Rear tow point of some kind.
Go through driveshafts and axleshafts to refresh ujoints and slip joints.
Hook up e-brake.
Good shake down to drive 750 miles round trip.
Wish list:
Tire carrier.
97+ intake.
WJ PS pump.
Rear locker.
Swaybar discos.
Remove the stance that has appeared in the front end (bad ball joints, bent axle tube...or?)
Updated:
Roof sliders. DONE
T'case skid. DONE
Rear driveshaft re-balanced.
Make sure cooling system is top notch.
Fix A/C.
Whatever happens at WinterFest.
- Ho-Boxes to fix rear leaf issue
- Fender trim in front
- Winch wiring (again)
Wish list:
Tire carrier of some kind.
Rear locker would be fantastic.
E-brake would be nice.
Got my new front shackles installed on the MJ so no more inversion.
Ordering a spare rear driveshaft today(DONE and sitting behind the seats ready if needed)
Getting a new CB/antenna this week (Friday) (DONE, installed & SWR set)
Have my winch mounting brackets ready just need to get my neighbor to weld it up so I can install my winch.
Ordered DOM and heims for my tie rod since LRG bent my tierod enough to worry me last year so I need to measure cut and have the inserts welded in once it all arrives...then hope it will fit OTK.
Need to hit the junkyard as I broke the driver side armrest on the door so I need to hunt one down. (FIXED)
Still need to shave the 14B so Nick won't yell at me
Need to get ramps made for my trailer.
Still hoping somehow I will have the money to put some swampers on the MJ...but I think I'll have to wait until next year. (NOT GONNA HAPPEN)
Have all fuel money a most of the cabin money already saved up and hidden...so other than these few things and topping off all fluids in the dodge and MJ we're ready!!!!!!!!! (MONEY READY!!!!! ) IS IT JUNE YET!!!!
Looks like my list got a little longer. Adding a front driveshaft, a better rear driveshaft than the temporary one that's too long, pinion bearing, and possibly gears if mine are screwed. Lord I hope I don't find too much else wrong or I'll be waiting another year.
Screw the pinion bearing, HP swap, if anybody know where I can get one for relatively cheap in good enough condition to just drop in give me a holler.
50% of holiday weekend!
Easter weekend is coming up.