- Location
- Mobile, AL
I have been looking around for D60s for a while now. I have seen all the threads on the swap and studied all the pictures. I just cant see paying $1000ish for an axle that I would have to do a lot of work to get it under my rig. I was wondering about the possibility of getting one of the Chevy 1ton front axles and modifying it so it is a drivers side drop. Has anyone done this? I have found plenty of 1ton GM axles for reasonable prices thought it might be an option. Of course, I am a cherry when it comes to axle tech, but I dont see why you couldnt just cut the long side off to the length you wanted it and weld the piece of tube to the other side. That was very dumbed down, but is that possible?
If I am way off here I am sure I will get blown in place, but I am ok with that....
If I am way off here I am sure I will get blown in place, but I am ok with that....