My son's 96 was making a lot of popping (sounded like someone hitting the frame with a small hammer). I traced it the trackbar mount at the frame. The track bar itself was not loose but the two lower bolts where loose enough to cause the mount to move left & right during any steering input.
The obvious was to tighten to spec which remedied the situation. Other than replacing the hardware all together, are there mods to strengthen this such aftermarket brace or perhaps lay a small weld bead approximately 1/2" long at each bolt location from bracket to frame rail?
Looking for ideas.
The obvious was to tighten to spec which remedied the situation. Other than replacing the hardware all together, are there mods to strengthen this such aftermarket brace or perhaps lay a small weld bead approximately 1/2" long at each bolt location from bracket to frame rail?
Looking for ideas.