98, 4.0, AW4. Getting a p0700/p0705. Cleaned NSS, tested. Still getting code. Adjusted, reinstalled. Bench tested. Still CEL. Pulled another NSS at yard, went to clean and it was immaculate. Installed and still get CLE. Pulled, cleaned anyway; sanded contacts. Bench tested and I get good contact though out the range. Installed and adjusted using a multi meter to verify all shifter positions. Still getting CLE. Cleaned grounds next to TCM, checked harnesses for broken wires. Verified connection to PDU starter relay. Still get CLE. Forgot to note I cleared codes each time. Always comes back after start up.
Also won't kick into OD. Adjusted trans kickdown cable. So now I'm thinking it's the solenoid(s). Is there a write up on testing them without dropping the pan, pulling and bench testing? I can't find a detailed method.
Also won't kick into OD. Adjusted trans kickdown cable. So now I'm thinking it's the solenoid(s). Is there a write up on testing them without dropping the pan, pulling and bench testing? I can't find a detailed method.