This is a follow up to a thread I posted earlier about replacing my Dana 30 yoke.
http://www.3dmodelprint.com/Jason/yokedifference.jpg
The new yoke is shorter than the old one, and I'm wondering if this is going to be a problem or not. Any suggestions? Can I knock that flange off?
Oh, I have a '99, and this is the part I ordered from PORC. I purposely ordered the u-bolt style after discussing it on the other thread, and was told it would make no difference to upgrade to it.
http://www.performanceoffroadcenter.com/oscommerce/product_info.php?products_id=1690
http://www.3dmodelprint.com/Jason/yokedifference.jpg
The new yoke is shorter than the old one, and I'm wondering if this is going to be a problem or not. Any suggestions? Can I knock that flange off?
Oh, I have a '99, and this is the part I ordered from PORC. I purposely ordered the u-bolt style after discussing it on the other thread, and was told it would make no difference to upgrade to it.
http://www.performanceoffroadcenter.com/oscommerce/product_info.php?products_id=1690
Last edited: