RE DB's and Braces w/ SkidRow Engine & Tranny skid??

IS everything going to fit? I just purchased the skids and I'm about to get some DB's and Braces. Im just wondering if im going to run into any trouble? Anyone else out there running this setup? Issues? Concerns?

Would it be beneficial to weld the braces to the frame?

TIA, Chris

I can't answer whether there's any interference with the SkidRow gear and the RE DBs.

However, I wouldn't recommend welding the DBs to the frame. See http://www.yuccaman.com/jeep/re_db.html for more info on installing the DBs.

back on up... anyone else have this setup? SkidRow says no problem but just want to make sure... Oh well we'll just have to make it work anyway.

I can't say anthing about skid row, but I have the RE DB and a rustys engine skid (ok got it for a deal) I had to modify the hoop over the front drive shaft to clear the upper control arm bracket. Just a little grinding.

The rustys and skid row front hoop look a like, so you may run into the same problem.

__________________________________________________ ________________
90' Xj Re 5.5", 4.88's, Detroit Dana 44 rear, locked front and rear rolling on 35" Xterrains with lots of trimming.

Visit us at www.pa-wheeling.com