Air release

[chelms27]

what is the best method to "blurp the cooling system?" I have looked everywhere, everyone says to do it on my 97, but what is the best method? Any advise would be great. Oh, and I have a 16lb cap, should I have something different? Thanks guys

[jeepsrock]

I was under the impression that burping these cooling systems was very important on the older pre 92 jeep and i dont think you need to on your 07. What i would do is run your heater for a while, run the engine at idle and have the thermostat cycle thru a bit. Basically drive it a few short trips and watch the level.

Make sure your thermostat has the stock air hol on the top and your pressure cap is normal and the correct one i believe.

pete

[goodburbon]

Not necessary to burp the 97.