canadianwheeler
NAXJA Forum User
- Location
- canada
Anyone know the socket sizes for the nut on the upper/lower ball joints on the d30 ?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Ball joint socket sizes?
- Thread starter canadianwheeler
- Start date
JonsXjProjekt
NAXJA Forum User
- Location
- Philadelphia, PA
Which nut are you talking about ? The castle nut?
CartsXJ
NAXJA Forum User
- Location
- Glenville, NY
obviously, bigger than any wrench size you have, HAHAHA
But seriously I am guessing in the 3/4 to 7/8 range, probably metric, everthing else on the axle is, so probably 19mm to 21 mm
But seriously I am guessing in the 3/4 to 7/8 range, probably metric, everthing else on the axle is, so probably 19mm to 21 mm
JonsXjProjekt
NAXJA Forum User
- Location
- Philadelphia, PA
22mm for the bottm castles the top i think were 19mm and the new ones from trw I think were 36 MM for the bottom but same for the top as the old.
elephantrider1
NAXJA Forum User
- Location
- FARMINGTON MO
well ive got a 96 and a 30mm is to small for the bottom i will find out 2marrow the exact size
ren
NAXJA Forum User
- Location
- frenchburg, ky
7/8ths for the top, and I think it was 34MM for the bottom. I just did the driver's side on 1 of my '88s' earlier this week. I actually managed to use hub socket (36MM) on the bottom nut!
