Who is using WJ lower control arms ?

Did you use go-jeeps instructions to widen the factory bracket or did you grind on the bushing? I am about to install a pair I aquired and want to know if the all-thread and washers worked for the rear bracket or if not how did you widen the bracket to make them fit?





__________________________________
1993 country 4x2 swapped to 4x4 dyno max exhaust
2000 intake 2 inch BB

TTT ANYBODY?

I ground the bushing to make them fit...it worked great

THANKS FOR THE REPLY , ANYBODY ELSE?

I ground them down, too, for the frame ends. For the axle-end brackets, I spread them a bit with a giant wrench and two small 1/8" thick plates (one on each side of an "ear" of the bracket. Now I'm back to stock XJ LCAs because the oval-shaped bushings for the frame end can't be purchased separately--just a whole new arm.