PDA

View Full Version : turning inner knuckles

xj paddler
July 6th, 2006, 18:25
what is the best way to get the inner c to break loose from the tubes. I have cut the weld s with a cut off wheel but the knuckle still does not want to budge. any suggestions???

later Heath
BrettM
July 6th, 2006, 18:32
make sure you can see the seam all the way around then BFH
HilltopXJ
July 6th, 2006, 19:26
make sure you can see the seam all the way around then BFH


X2
Midnight Krawler
July 6th, 2006, 20:10
Use 2 BFH's.
rehab
July 7th, 2006, 00:58
Use 2 BFH's.
hell why not 4 and another guy pulling on it? and a 5th heating it with a torch
HilltopXJ
July 7th, 2006, 09:24
hell why not 4 and another guy pulling on it? and a 5th heating it with a torch


Or you could hit it with a rusty ranger axle... :roflmao: :D
xj4life
July 7th, 2006, 10:01
as stated, make sure you can see the seam. then heat throughly, even with just a propane torch and whack with a hammer.