HP44 Few quick questions

I have searched for 2 days...
here is what I have 95 4 door XJ 4.0L, AW4, NP231. HP44 out of a 78 F150.
Somewhere around 6" or so of lift.

Using the "ford style radius arm"

So
Front driveshaft-retain stock? or does it need to be lengthend?

Front Track bar-pictures please. I have tried to search on that as well

I am about 2 days from being finished, however I believe I have the axle shifted too far forward as the D/S will not hook up

Please be gentle...It has been 90* + all weekend and my mind is fried.
thanks in advance for your help.
J

if the jeep is in a position that it is possible. Put the tires on the axle, and center the tires in the wheel well. that will tell you where is should be.

well I would do that however I was trying to get all of my building on the axle done first before I geared and sealed it.
J
thanks though

My front shaft was barely short enough, but you are probably moving your axle farther forward than I did on mine. I welded my trackbar bracket in place when everything was under the rig and centered.