xj4life
NAXJA Forum User
- Location
- LaPorte, IN
Does anyone other than Motive Gear make shafts for the Explorer 8.8?
Anyone run 8.8 aftermarket shafts with any success?
Anyone run 8.8 aftermarket shafts with any success?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
8.8 Aftermarket Shafts
- Thread starter xj4life
- Start date
- Location
- Foresthill, CA
4 years on Dutchmans. Broken a housing and an ARB with no damage to the shafts.
Highly recommended.
CRASH
Highly recommended.
CRASH
- Location
- Denver, CO
CRASH said:
Out of curiousity...how'd the housing break? I hear the tubes can twist...
/thread hijack
- Location
- Foresthill, CA
hjeepxj said:
And bend.
Traction bar was the culprit. And not enough weld around the case. And too much throttle.
New one is fully welded, with a truss, and extra plug welds.
CRASH
xj4life
NAXJA Forum User
- Location
- LaPorte, IN
CRASH said:
i plan on getting my 44 shafts from dutchmans. didnt see 8.8 shafts on their website. guess i'll give them a call on those.
xj4life
NAXJA Forum User
- Location
- LaPorte, IN
i see them now :homer:
- Location
- Denver, CO
CRASH said:
Good to know.
96country
NAXJA Forum User
- Location
- Russellville, AR
I've been running Yukons in my 8.8 for about 6 months now. No problems at all.
