Ron Hyslop
NAXJA Forum User
- Location
- Madison, WI
Anybody know off hand if a Renix 4.0l throttle body will bolt up to a 92 HO in take manifold? If not, will the intake and exaust manifold from my 87 4.0l bolt up to a 92 HO? TIA
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Renix and HO compatibility?
- Thread starter Ron Hyslop
- Start date
5-90
NAXJA Forum User
- Location
- Hammerspace
No twice - what exactly are you trying to do?
The RENIX Tbody uses a 3-bolt circle, while the HO uses four.
The intakes are also different - the RENIX port sits lower and has a largish "relief" for the fuel injector, while the HO ports have been raised.
You can, however, change the head as an assembly.
More info, please.
5-90
The RENIX Tbody uses a 3-bolt circle, while the HO uses four.
The intakes are also different - the RENIX port sits lower and has a largish "relief" for the fuel injector, while the HO ports have been raised.
You can, however, change the head as an assembly.
More info, please.
5-90
dangerranger
NAXJA Forum User
- Location
- MN
you can use the HO intake and mainifold in a non ho body, at least a '90. i switched a few cables , rewired the tps, and swapped fuel rails
Ron Hyslop
NAXJA Forum User
- Location
- Madison, WI
My 87xj 4.0l engine is tired, lots of blow-by. I saw an add in the classifieds for a 92 Jeep 4.0l with 67,000mi for $1000. It did not say if it's an Cherokee, Grand cherokee or Wrangler engine. Going to call the guy tomorow.
