No More Death Wobble

I just thought I would pass this along. My 88 Cherokee has had an intermittent Death Wobble ever since I installed a 2 inch lift. I had the allignment done right after and still had the problem.
What seems to have fixed it is replacement of the lower control arm bushings. They were cracked beyond belief. The steering is also much tighter. I had no idea what an improvement in handling this one change would make.

Did you replace them yourself, and how long did it take?
What bushings did you use?
One side at a time?
Just looking for some more info.

Thanks

IMO, there is no need to waste your time with the LCA bushings. Quadratec has new arms for about $20 each with bushings in them. It is also the same with the Upper arms, the only bushing you would have to RR is the UCA bushing on the axle side.

I did replace both arms also, but they do have stock rubber bushings. Again, major improvement in handling. The hardest part was applying the required 133 ft-lbs of torque while on your back. Good luck

I had a lot of problems with this also I changed the bushings and also the sterring stabilizer

what a diffrence...