jeepfreak1020
NAXJA Forum User
- Location
- Thornton
So I'm getting ready to weld on my ube kit on my 9 inch and need to know what the measurement between the two of them are. Center pin to center pin.
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Leaf perch to leaf perch measurement needed
- Thread starter jeepfreak1020
- Start date
VAhasnoWAVES
NAXJA Forum User
- Location
- Lake City, Mi
not really answering your question... but most people simply bolt them onto the leafs and put the weight of the jeep on the axle (taking precautions obviously) in order to dial in the pinion angle.
jeepfreak1020
NAXJA Forum User
- Location
- Thornton
Normally I would do that. But I won't have a drive shaft built yet because of different size u joints so it won't be built. And second I won't have a 220 any longer when the axle goes in. So I need to weld it on now, and will just run shims. Always ran shims and never had a problem.
xjwisconsin
NAXJA Forum User
- Location
- sturgeon bay, wisconsin
Can you mock up the drive shaft with some PVC?
jeepfreak1020
NAXJA Forum User
- Location
- Thornton
Not really because of the double cardan. You can't really get a exact measurement. I have no problems running shims. I always have. I have a shop that custom makes them. For cheap to. I just need the measurement.
