Pinion preload?

I am in the middle of changing my pinion bearing. Just had a couple questions. and wanted to make sure i was right. Pinion nut torque is 200-220 ft/lbs correct? and the pinion preload is... not sure want to say around 20 in/lbs? anyways thanks for any help. i have been searching for hours with no for sure answer. Its a Dana 30 rev with the shims not the crush sleeve.

Thanks

14-20 should do ya.

which bearing are you replacing? inner or outer?

as long as you retain the shims and torque the nut down you will be fine.

Its the outer bearing. im pretty sure the preload was wrong before that is why it went bad.