userbmx1315
NAXJA Forum User
- Location
- Dallas, NC
been trying to get my jeep aligned forever now.
current set up is, d44 with ballistic buckets, RE upper mount bridge.
the trac bar with lowering mount, is a RC thats cut down to fit.
my trac bar and tie rod are parallel.
were do i start?
i put an electronic angle finderon thr upper ball-joint and had 6*
ive pulled a tape from center tire to center tire to center them. (pulling them in 1/8, read 1/16 to 1/8 on go jeep sight i think it was)
ive added JCR's poly bushing to the pass tie rod.
i just dont know were to begin, again.
current set up is, d44 with ballistic buckets, RE upper mount bridge.
the trac bar with lowering mount, is a RC thats cut down to fit.
my trac bar and tie rod are parallel.
were do i start?
i put an electronic angle finderon thr upper ball-joint and had 6*
ive pulled a tape from center tire to center tire to center them. (pulling them in 1/8, read 1/16 to 1/8 on go jeep sight i think it was)
ive added JCR's poly bushing to the pass tie rod.
i just dont know were to begin, again.