Like the title says, so what is it? The reason I ask is because I might be going with bilstein 5150's and they seem to use 1/2" or 12mm bearings instead of bar pins on top and bottom. So.... I would need at least one set of bar pin eliminators for the rear uppers. One set of shock conversion mounts for the front uppers and one set of bar pin eliminators for the front lowers???
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Rear lower shock mount OD size???
- Thread starter 4LVLFWD
- Start date
RCP Phx
NAXJA Forum User
- Location
- Phoenix,Az
Stock rear lowers are 5/8".
with the eb1 type bushings, can i run a 1/2" or 5/8" sleeve with the same bushing? or do i need a whole new bushing to run diff size sleeves?
lazyxj
NAXJA Member #1310
- Location
- Los Angeles
Bilstein has a bar pin adaptor for the 5150. Use them if you need the up-travel.
http://www.shockwarehouse.com/site/product.cfm?id=30579
Both the top and bottom bushings are 5/8"
http://www.shockwarehouse.com/site/product.cfm?id=30579
Both the top and bottom bushings are 5/8"