jwalter04
NAXJA Forum User
- Location
- Bristol, Connecticut
Trying to splice the wires for my O2 sensor that got ripped off by my drive shaft. anyone know which wires go to which? I've got two white ones coming off the sensor itself too. HELP ME
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
need help now
- Thread starter jwalter04
- Start date
- Location
- Rainy side of Washington
Get a Haynes manual or an FSM for your model year - it should give you enough information that you can figure out which goes where using a multimeter.
wim hoppenbrouwers
NAXJA Forum User
- Location
- Netherlands europe
Hallo. The Zirconium O2 sensor has 4 wires.
Sometimes 2 whites for the heating element and one grey for the ground and the black one for the data.(generates its own voltage signal to the ECU. 0.1 -1.0 Volt) :helpme:
Sometimes 2 whites for the heating element and one grey for the ground and the black one for the data.(generates its own voltage signal to the ECU. 0.1 -1.0 Volt) :helpme:
piknpul89
NAXJA Forum User
- Location
- california
Strip the wires back and twist them together,when you find the right combanation,make your splice permanent.
wim hoppenbrouwers
NAXJA Forum User
- Location
- Netherlands europe
Hallo. Always use the OEM connector with its wires. No soldering.(esp.the black one)
Last edited:
