RE weld on sway bar mounts

Re part number RE9992 Has anyone ever used these and if so do they raise the mounting point higher(that's what I need). The description says control arm but we all know better..
http://www.rubiconexpress.com/Products.aspx?part=RE9992
this is the part that welds to the axle

And does anyone have a pic of them installed. My steering hits my lower part of my sway bar link disco. So I need to fix this issue and hoping that these will allow me to raise my mounts up a bit(like 2")

anybody. I was also shown these. Which I think might be a bit better..
http://store.jksmfg.com/merchant2/m...0_915&Store_Code=JKS01&Category_Code=FABParts

magimerlin said:

anybody. I was also shown these. Which I think might be a bit better..
http://store.jksmfg.com/merchant2/m...0_915&Store_Code=JKS01&Category_Code=FABParts

Click to expand...

I have not done this yet, so I do not have a good answer.
Check to link below to see how Go Jeep made his own and how its done, including measurements.
http://www.go.jeep-xj.info/HowtoOTKSwaybarBrackets.htm

lazyxj said:

I have not done this yet, so I do not have a good answer.
Check to link below to see how Go Jeep made his own and how its done, including measurements.
http://www.go.jeep-xj.info/HowtoOTKSwaybarBrackets.htm

Click to expand...

nice find thank you. they even had a click able template that i printed out. now to get some metal and cut them out