RWKHausSupply
NAXJA Forum User
- Location
- yorba linda, Cali
Selling my Edelbrock Alum head and port matched intake.
Willing to take $1500 for the head and matched intake. And depending on where you're located, shipped.
everything is off and boxed. Just a intake and bare base head will cost you just about $1500 shipped. Youre getting a one of a kind fully built and ready to go race head and port matched intake.
For $150 more I will throw in the BBK 62mm blinged out throttle body for a 91 to 03.
http://www.bbkperformance.com/produ...dies/1991-03-40l-jeep-62mm-throttle-body.html
This head was bought new and given to Russ to open up and flow and build. It flowed more than most anything out there in this head at that time. More than any iron head he has ever done he said.
Some pictures of when it was new below.
I have to smog the jeep and I likely will be selling it after wards, so I am putting a OE head on the stroker and much smaller cam etc.
I have about $2400 in to this head and port matched and polished intake.
Used about 500 miles.
Located in Yorba Linda
When it was new, the Head with the red machining dye...
Actual and current photos of yesterday when it was removed. Needs int/exh gasket material removed. Can still see the marking stencil that Russ performed for the port/polishing.
Willing to take $1500 for the head and matched intake. And depending on where you're located, shipped.
everything is off and boxed. Just a intake and bare base head will cost you just about $1500 shipped. Youre getting a one of a kind fully built and ready to go race head and port matched intake.
For $150 more I will throw in the BBK 62mm blinged out throttle body for a 91 to 03.
http://www.bbkperformance.com/produ...dies/1991-03-40l-jeep-62mm-throttle-body.html
This head was bought new and given to Russ to open up and flow and build. It flowed more than most anything out there in this head at that time. More than any iron head he has ever done he said.
Some pictures of when it was new below.
I have to smog the jeep and I likely will be selling it after wards, so I am putting a OE head on the stroker and much smaller cam etc.
I have about $2400 in to this head and port matched and polished intake.
Used about 500 miles.
Located in Yorba Linda
When it was new, the Head with the red machining dye...
Actual and current photos of yesterday when it was removed. Needs int/exh gasket material removed. Can still see the marking stencil that Russ performed for the port/polishing.
