sjx40250
NAXJA Forum User
- Location
- Alexandria VA
I am sure this has been covered many times. If so, just reply with the link, if you can find it!
1990 XJ 4.0 with AW4/242 4" lift with OME springs. I have a front drive shaft from an 1989 same config and measures very close to 30 7/8 center to center u joints.
The rear drive shaft is installed but has a bit of a vibration, not much. It measures about 30"
The yoke in the T/C has moved out about 1/2."
Will a hack n Tap work? I read that it applies to 4 1/2" lift and more. What do you suggest?
1990 XJ 4.0 with AW4/242 4" lift with OME springs. I have a front drive shaft from an 1989 same config and measures very close to 30 7/8 center to center u joints.
The rear drive shaft is installed but has a bit of a vibration, not much. It measures about 30"
The yoke in the T/C has moved out about 1/2."
Will a hack n Tap work? I read that it applies to 4 1/2" lift and more. What do you suggest?