• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Search results

  1. 8

    AC clutch bearing must be bad...options?

    Started the 91 Laredo today for the first time this winter and through all the accessory belt howling and squealing came some smoke. Investingating it was the AC clutch getting hot enough to on turn off, it melted the belt. So I get a new belt and install it. but that won't solve the problem...
  2. 8

    Rear sway bar frame brackets. Source?

    Lost a rear sway bar bracket the other day, rusted. 91/4.0 daily driver, not wheeled so maybe I would like to put the bar back on but since it seems the bracket is not a separate item, only direction is the aftermarket bracket kits. Any other options or is this bar coming off? Thanks.
  3. 8

    Radio and Wiper electrical issues

    91 Cherokee 4.0 Radio only puts out sound when warm/hot. Does everything it should except make noise through the speakers when cold. Wipers (with intermittent) will sometimes just stop mid-path. I have cleaned the intermittent module connections. Bushings have been replaced so the wipers...
  4. 8

    Radio not working. Did it die?

    91 stock stereo with aftermarket speakers added years ago. Radio lights up just fine. Radio turns on just fine and the antenna goes up Sux a tape in just fine Channel change just fine Lights up as it should with the lights on but No sound No sound on tape This was intermittent, resolving...
  5. 8

    Steering wheel wobbles side-to-side

    Jeep off, key out, and the steering wheel wobbles left to right a good bit. There is less wobble top to bottom. Any way to get the wheel all tightened up again? 91 XJ
  6. 8

    Serpentine belt idler bearing: 6203-2RS

    So thanks to NAXJA I found this number while searching. I know I could have bought an idler pulley for 16 and change or shipping or whatever, but my local Fastenal has the 6203-2RS in stock for $2.08 plus tax. The bearing install slowed the job by about 5 minutes, pressing the old bearing out...
  7. 8

    Fixed high temp gauge reading

    Try cleaning the electrical connections to the sender. So my 91 had high temp readings during the last two summers. NBD didn't overheat so I drove it. Well the other day 85 degrees out and traffic, it got real hot. Finished the drive and turned for home. Stopped for a quick trip to Costco...
  8. 8

    Using NP 231 in 4WD in heavy water, dama`?

    Using NP 231 in 4WD in heavy water, damage? So when the standing water on the road surface is more than 1/4 inch, I sometimes put my 231 in 4WD (high). I know the 231 is a Part Time 4WD system. Other then sharp turns and the front end complaining what problems will this cause? Go ahead...
  9. 8

    4-Bolt Exhaust Flange for Cat. Is there one avail?

    Well I tried to put it all in the title. I have searched and seen that there does not seem to be a 4-bolt flange available for the cat except on direct fit cats. My XJ has an aftermarket non-direct fit cat using the old flange and about 4-5 inches of the old cat inlet pipe. I'd rather...
  10. 8

    Found this spring in the driver's door...

    The door works, but I was wondering where it is supposed to be in the driver's door. You can see the top coil is broken.
  11. 8

    Driver's window problem fix

    Well the driver's window in my 91xj 2-dr has been intermittent for some time. I have been able to get the window to work by opening the door, nudging the wiring harness between the door and chassis or just driving. Since the window decided to quit today I decided to do something about it. So...
  12. 8

    Thanks, new windshield with gasket not trim

    So after reading months ago that the newer windshield gasket can be used on the older XJs, I had my windshield replaced and used the gasket. Did not need to remove the tabs that mount the clips, just the clips. Really cleans up the looks, and I'm expecting lower wind noise at speed. Should...
Back
Top