Search results

Yeah, i'm familiar with brake line clips, this looks nothing like it. Dealer should have this part for a few bucks.

Just looked at my 94...it is a clip. Square with open in center with "finger" to lock bolt in. Dont know what you call that style clip..

Will a 97+ overhead console fit in a 96 or older XJ? Thanks..

I have a tan column with key from an 86, also have all the glass for the doors. Located outside Philly, email [email protected]

I have one on an 85...were they all the same? Located outside Phila. Have a pic of the one your needing? [email protected]

I have an 84-85 parts XJ with 2.5, engine has Rebuilt tag on the block. Auto trans which needs new front seal, it leaks ATF. Email me if you'd be interested in a road trip to the Phila area. [email protected] John

I stated above that i dont have the check from closing said account...it's been lost. I'v emailed Eagle with directions you'll have to take to get another check cut. Now if you'd like to stop by and pick up the bank statements from this prior account i'll be happy to supply you with them. When...

Please allow me to publically make a statement. As most know i have in the past been the NAC Founder,President and Treasurer. Due to complications in my life with health and new Career i stepped down from these positions. I'v recently been asked where the funds went from the last account the...

Danno, PM me your address. I have title and plate for ya, thanks again for the flares you shipped out to me for free. :) John B

Joe, give Jack at No Excuses a call 800-923-JEEP. He hooked up a bud with 4 for $200.

Ben, any chance we can do this again in Sept? I'm sure Mitch would be up for it....

This started out as an "Iron in the Pines" club event held on the Holiday weekend. It's grown over the years...espescially after the rumored ;) wet T contests. Alot of the guys have fullsize rigs on Rockwells and tractor tires. My neighbor has an S10 on 58's and will be there, dont miss an...

My OTC brand press #7249 came off a Snap-On truck and cost me almost $150. I think it was Harbor Freight who also carried it for ~$100. It's come in handy for myself and several in the NAC...

Update: Tapco does not carry the Timken brand hub bearing assemblies. Too bad...the price was right too. Looks like i'll hit AutoZone.

One thing you'll need to replace on that non HO transmission for use with an HO motor is the throttle kickdown cable. The non HO will be too short. It's simple once you remove the trans pan. The end of the cable has the barrel like a bicycle brake cable.

Not hiding Scott...just been real busy with new job and remodeling the house. :angel: I'll hit ya backchannel.

I had heard some were getting them that cheap but didnt know the source. Thanks guys..

Who's got the cheapest price on Timken unit hub bearings? :confused:

When ya see the Green XJ at camp along the Penobscot past Millinocket make sure ya wave! ;) Hey Nick....call me.

I'll be in Maine the same weekend....camping somewhere near Millinocket or further North near Baxter SP or the Allagash. I'm not sure where the area you mention is but if you would like to meet up for a trail ride or a few cold ones email me at [email protected]. John B