Search results

Has anyone found much luck using a different rear spring application swapped in place of XJ leafs? I am wanting a leaf with less offset, more spring rate, slight lift (3") and close to the same overall length.

I just though I would post this info so it might help some poor fool like me in the future. 1992 4.0 AW4 running rough, seemed like it wasn't getting enough fuel. Checked pressure at rail, found it was 20 PSI while cranking and running. Turn key off and the pressure would bleed off quickly...

Would a faulty O2 sensor prevent or seriously hinder startup? Would a bad O2 sensor always throw a code? MY 92 XJ with 4.0 and auto sometimes starts right up with little cranking, but lately, most times it will crank for quite a long time(minutes) finally start, run rough for a few seconds...

My 1992 XJ 4.0 AW4 with 150K on it has been getting worse. It first started while I was offroad, doing some mild tippy wheelin. It would cough and sputter and die like a carbed engine does, start after alot of cranking and pedal messaging, then it would run fine after a while. At first, it only...

I am going to start a tube chassis for my XJ drivetrain. I would like to simplify the wiring and electrical components down to what I need. What sensors and other components should I keep and what can I delete without harm to the overall performance of the drivetrain? I won't be using the heater...

I have been having twitchy NSS problems for a while, bumping the shifter usually fixes that. This time, after some good wheelin time, I couldn't get it to start. TRied the key while rowing the shifter back and forth, It won't crank, just clicks. Banged on the starter while trying to start...

I thought some of you might appreciate this. The holes might be exact, so you might want to drill your holes a little big. I used 1/4" thick, but IMO 3/16 would be plenty. Everything is measured from the front edge of the frame horn, back to the center of each hole. I took my square off of that...

Does anyone have a DXF or other type of computer generated drawing of a steering frame brace? I would like to make some laser cut frame brackets to incorporate into my front bumper. Searching did not yield much talk of such a file.

Now that I have my $700 XJ, I constantly worry about someone taking my sweet ride. Pep boys used to carry a metal collar that covered the steering column so the dirtbags could not access the keyswitch gear by breaking the plastic on the left side of the column. Does anyone on here have one of...

Alright folks, lets see your homebuilt, buddy built, paid for with beer bumpers. I don't want to see anyone with a "Fabberguy.com Offroad Enterprises" bumper that you put on your mom's Visa, I want to see bumpers you or your friends have built. Yes, I searched. I saw lots of red X's. Show me the...

Come one.... you know you are out there! This baby is a genuine AM/FM/CB/8-track stereo! That's right CB!!! Made by Cobra. I also got my Abba 8-track tape ready to go in that sucker!