Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
I run the Rubicon Express trackbar, bracket and brace setup.
I have a ZJ pitman arm on it but it's not enough drop to match how far the trackbar was dropped.
Looking around the web, I see that some of the drop pitmans sold for lifted xj's & tj's don't offer any drop for a ZJ, so I assume it's...
I have a 94 model 2wd that I am converting to 4wd using a '91 model with AX-15.
I am stripping down the the '91, I know all the hard parts that I need, I bought a used front axle with 3.55 to match the rear axle under the '94 as well.
I'm just wondering if there is any wiring that I need to...
1994 2wd Xj 4.0L engine 2wd with auto trans 157,xxx miles.
I'm trying to figure out what happened.
Previous owner replaced crank position sensor and ignition coil about 10k miles ago.
Has ran great until I hit a big bump.
I'm thinking there is a short somewhere but have exhausted myself...
Starting to get my little novice backwoods rig headed in the direction that i wanted it.
Wanting to know it anyone ever cut and folds the rear fender seam for more clearance.
There's also a similar seam in the front fender well that I've seen cut and folded on other folks rigs...
Some time in my Heeps journey though life, a previous owner put bolts with nuts on the rotor side of the knuckle through to hold the caliper on.
I'm not sure if the old ones had to be drilled out or the bolts passing through smoothed the threads out.
But what I do know is it doesn't work, the...
I'm thinking about using a set of the spring plates offered that have a spot for the bump stop to be mounted or for it to make contact.
Are there any issues with over stressing the u bolts or any other known failures while using them.
My setup will be 4" lift with shackle relocators and 33"...
Upon searching for information about the Superlift 550 coil spring, all I found were unanswered questions from other folks wanting to know the same stuff I was wanting to know.
Being that I actually live somewhat close to a Superlift warehouse I decided to go check them out.
After seeing the...
I have a '91 XJ in stock form with 3.07 gear ratio.
I can buy a complete '96 ZJ front axle for a decent price with 3.73 ratio.
I'd like to have non disconnect axles and a lower ratio carrier for my axle.
Will any of the differential parts interchange from the newer low pinion axle to mine...