Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
I’ve been chasing an overheating problem going on three years.
Jeep overheats at idle.
Every summer my Jeep overheats, I change parts all summer and never fix it until the weather cools down and the problem goes away.
2018:
-moved to Las Vegas and my overheating problems begin
-replace...
99 Jeep Cherokee
4.0 Liter
Since last year gradually changed:
Fan Clutch
Electric Fan
Thermostat (Super Stant 195)
Water Pump
Drive Belt
Radiator
Been acting up recently so I finally changed the radiator.
Before installing the new rad, I did a super flush with preston flush, drove it...
99 Cherokee Limited 4.0L
I was troubleshooting a "no bus" gauge cluster message and found a wire plug not fully seated behind my steering wheel. I plugged it in not knowing what is was to fix the issue. After that...my jeep will start for a few seconds and shut off.
After doing some research...
Hello,
1999 Cherokee Limited 4.0
I've installed a remote start on my cherokee. It successfully turns on my jeep but doesn't run the blower motors.
They turn on when I put my key in and rotate forward.
I searched through threads and found this post:
I don'tunderstand. black/orange is...
1999 XJ | 4.0L | 140K Miles
Sorry for another engine knock thread, I've done hours of research, searching forums and this is my last resort.
PROBLEM
Engine sounds like a diesel when idling. knock or tick (idk the difference)
Here's an audio file...
1999 limited - 6cyl/4.0.
Had a rusted freeze plug - causing slow leak and over heating.
Removed valve cover, head cylinder, fuel injectors, intake manifold, exhaust manifold.
Took head cylinder to shop. No cracks. Had it Cleaned it up, new valve seals installed.
Inspection of parts:
1)...
So I had overheating problems and Jeep was leaking bad in the back near the firewall.
Just took off the head to get to the gasket and saw where the water was coming from. Shooting out of these holes onto my firewall like a hose.
Is this a common thing?
Sent from my iPhone using Tapatalk
I've got a 96 XJ. with rough country 3" lift and 2" spacers.
My sway bar link on left side is rubbing against my coil. How do I fix this? I've searched for hours.
Thanks guys.
Sent from my iPhone using Tapatalk
The Jeep also makes a clicking sound like it's coming from behind my dash on drivers side.
The sound increases in frequency as the car increases in speed (not the engine RPMs)
Clicking sound/vibrating gas pedal occurs when Jeep is at steady speed, and loudest when decelerating, never when...
Hey all, my 99 Limited has factory keyless entry. I don't have a fob for it but also don't plan on finding/programming the original one.
I want to replace with this: https://www.amazon.com/dp/B0096DLZLK/ref=cm_sw_r_cp_api_oGRIybVZB90ZT
Has anyone wired in aftermarket Keyless entry? Is it as...
Engine starts maybe 1 out of 15 attempts when key is turned.
Do I just need to order a replacement ignition lock cylinder?
http://www.carparts.com/details/Jeep/Cherokee/Replacement/Ignition_Lock_Cylinder/1999/REPP503901.html?TID=gglpla&origin=pla&gclid=CMvBlJnZs9ECFRMHhgodQAUBVg&gclsrc=aw.ds...
I know it's a magical vacuume sphere. The line cracked from being old and brittle, how do I fix it? Hook up a new line and good to go?
Sent from my iPhone using Tapatalk
Sorry, if this has been asked/answered before.
I have searched for hours on NAXJA and other threads, but have not found a write-up or anything that answers all of my questions.
I just purchased a 1999 XJ (4.L). The AC does not work and hasn't worked for years.
I have already determined two...
Hello all,
My first post, but I've been lurking about, reading your posts for a few years here and there like a creepy neighbor.
I have a 95 XJ with stock NP231 Transfer case that has gone bad (horrible noise when front drive shaft is rotated)
My question is: Should I replace the Transfer...