Search results

High Clearance Micro Camper, built on military jeep trailer frame.. -lightweight -5x9x3.5 -sleeps 2 -carpet -2 sliding windows -roof vent -insulated -rear stabilizer jacks -fold out table/shelf -adjustable hieght pintel hitch -stay warm and dry, don't mess with a tent $1000 or best offer...

1994 Jeep Cherokee Country 153k 4.5" front springs..(ACOS not installed) 6.5" rear springs (1.5" boomerang shackles not installed) JKS sway bar disconnects, and rusty's track bar rusty's fender flares engine, trans, and gas tank skids, as well as rock rails Currie ford 9in rear with...

I am trying to sell my jeep,, got back into racing dirtbikes so I don't have time to really use it,, i have no idea what its worth so the price at the bottom may make people laugh.........oh yeah ill try to post a picture or two later it has..... 140,000 miles 4L 4-door power everyhting Alpine...

I am trying to sell my jeep,, got back into racing dirtbikes so I don't have time to really use it,, i have no idea what its worth so the price at the bottom may make people laugh.........oh yeah ill try to post a picture or two later it has..... 140,000 miles 4L 4-door power everyhting Alpine...

i have a line on cheap parts locally, but he shows cv style axles in the front,, its a d30 non abs by the way

Being the moron that I am I was helping a friend cut broken trees Isabel left behind,, I pulled a little too hard and exploded both axles in the front of my d30,, what are some good complete front axle units that i can buy,, thanks

So check this out,, i placed an order for 2 bumpers , front and rear way back in may,, still have not gotten them,,, after talking to and getting the run around from them for 3 months I finally called to cancel, Brent said that was fine but that he didn't have the money to give me back right...

I put a 1.5" lift shackle on the rear to compensate for a heavy bumper,, my pinion was already pointed TOO high (above the driveshaft) I have 6 degrees of reverse shim to point the pinion further down,, i guess my question is is it smart to put more than 6 degrees of reverse shim or should I...

does anyone know offhand the leaf spring width?? I need to get some degree shims, but i don't have my jeep with me,, thanks

I also will have the fenders cut with Rusty's flares, will they fit and with what backspacing??,, thanks

my newly installed rear has a backlash problem I think, when I go off/on with the gas (lightly) it clunks and at very light throttle it sounds like a chatter, is my backlash waaaaay off?? and will this hurt it?? I have only put about 10 miles on it, and Im scared to drive it, Im guessing I need...

I just installed a currie 9" and I have a question. I think I know the answer to this but do I have to unbolt the 3rd member to drain the fluid.. I just installed it and am going to start breaking the ring and pinion in tonight but I wanted to change the fluid at 500 miles or so, thanks

has anyone used the "push in" type fittings for the airlines that come with the sun performance air locker kit?? just wondering if they will leak??

I have a new OBA sytem using a Viair compressor and a 2.5 gallon tank,, my my question is can the compressor be install upside down?? I looked on the website and didn't see anything that talked about it,, Im guessing that it can be because its oiless but I wasn't sure,, also the kit I ordered...

will I be able to use my stock brake setup? or will I need a proportioning valve, or diffrent booster?? thanks

I remeber seeing this awhile back, I think it was an email address to request a build sheet,, you send them your VIN and they send you back the build sheet?? any help,, thanks

I just ordered all the stuff to regear and lock both my axles,, I have never done this before,, although I am very confident mechanically,, Im not sure if I should attempt this or just take it somewhere and let a Pro do it... ?? they are a 8.25 and a d30 by the way,, comments, advice thanks

i found an 87 xj d44 for $350 close enough to pick up ,, now are they all the same??,, when I go get it what should I look for?, Im going to rebuild it and drop a new r+p and an electrac in it, but are there any diffrences or reasons it shouldn't just "drop" right in?? thanks

i am going to order a DTS d60 with discs and electrac locker with 4.56s for $3209,, how long will the d30 last with 35s in the front?? open diff for now,,, is the d60 overkill?? opinions please... thanks

I am going to get a new rear axle for my XJ,, I really want to order it complete, with discs, and a locker,, I have 33's now, but plan to go bigger,, I was wondering if a d44 is good enough, or should I just get a d60 while Im at it,, also I was going to get a electric locker put in it also...