• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Search results

  1. M

    AW4 Fill Tube

    What's the size of the bolt holding the trans fill tube to the bell housing? The XJ I bought recently doesn't have one. 5/16 coarse? Also does the vent tube for the transfer case bolt there too? I'm use to the AX15 so unsure on this one.
  2. M

    Dying intermittently

    1986 XJ with 93 YJ 4.0 and AX15. Died on my way to work back in December. Crank but no start. Restarted several hours later and now will die after driving for about 1/2 an hour. I can get it to restart by disconnecting the batt for about 60 seconds. Only throwing code 33 and 12. Fuel pressure...
  3. M

    Stalling, hot no start

    Alright, this might be a little long but the more info the better right? 1986 XJ with 93 4.0/ax15 from a ZJ. About 2 months ago I was running into some drivability issues. It will occasionally die when coming to a stop and i disengage the clutch. I can pop it back out in second and it fires...
  4. M

    T-Case linkage

    Finally got transfer case linkage hooked up for my XJ. It is an 86 that originally had the 2.8/ba10/207 and now has a 93 4.0/ax15/231. Needless to say the linkage didnt cross over. I bought some 3/8x24 ready rod and 4 heim joint rod ends to match. The company i bought it from does have the...
  5. M

    AMC 15/Dana 35

    I know these are essentially the same axle and the switch happened sometime in 86. I have an 86 that is confusing the hell out of me. It is time to do rear axle seals and since it is non c-clip i'm doing bearings and as well. Here's the confusing part. I looked up on alldata and it shows the...
  6. M

    Window Sticker

    Don't know where to post this but I found the original window sticker to my XJ. Interesting to see what they charged for everything. It was pretty pricey for 1986. The guy I bought it from is an old family friend who purchased it new in 86. Still has the Berthod Motors badge on the back. Take a...
  7. M

    Stalling when warm at higher RPM

    1986 Chief with a 1993 YJ 4.0 and AX15. Recently the thing has been trying to die when it reaches operating temp and above 1200 rpm. I can hear the fuel pump and before the engine bogs down it sounds llike the fuel pump quits. Push the clutch in to take the load off the engine and the fuel pump...
  8. M

    86 XJ with TJ drivetrain

    I've searched high and low but only came back with minimal info on this. I'm picking up an 86 XJ from a family friend for 500. It has had the old 2.8 swapped with the entire drivetrain from a 2003 TJ Wrangler. 4.0 HO, NV3550 five speed, and NV231 transfer case. He's run it for about 60,000...
Back
Top