Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
So I rebuilt my NP231 when I installed my SYE kit, my speedometer worked before I pulled the transfer case out but now it does not. I made sure that the cable is plugged in on the transfer case but no dice. Any advice?
I ended up getting it done by taking the bracket off and grinding mainly the bracket but also the block just a little. It installed nicely after that and there is a noticeable improvement in power. I’m going to be going to the JY and pulling numerous ones and pre grinding them and then powder...
Hi guys, so I upgraded all of my factory wiring so,that I could do the alternator upgrade. I got my new alternator in earlier today and after some headache, I got the new one to fit back in the place where the old one was removed. My issue is the new case is larger and the alternator hits the...
I ended up taking a Dremel with the precision tip and slowly, very carefully grinding away at the bearing until it was brittle enough to crack and be slid out. Then I used AT4 and my ball joint press to install the new one. It was crazy tedious but it worked.
Sent from my iPhone using Tapatalk
So I’m rebuilding my transfer case and I’ve replace all the bearings except for the incredible pain in the ass needle bearing that is in the smaller case half, I cannot get a puller to fit. The guy at the auto part store said something about moist bread, but that sounds about as reasonable as...
Going with a lower temp rating thermostat isn’t going to fix your problem. I live in the Deep South and I can run my Jeep in traffic with the AC going and it goes just a tick over the mid mark. Did you make sure you really flushed the motor? Are you sure your electric fan is operating...
If you want to lose the fan clutch all together you can and go with a three electric fan setup and you’ll lose the drag that the clutch fan puts on the motor. Plus the fan only puts out low cfm’s at best.
Okay so I was able to press the upper ball joint in straight and it went in with no real issues, but now that I’m trying to reinstall the spindle the entire ball joint shaft is spinning as I turn the castle but. Is the ball joint toast? I used the proper sleeve and that part of the ball joint...
I’m going to try your method in the morning Rob. I bought some 1/4 inch flat stock for this project. Thanks for everyone’s posts. I know I should use the proper tool, but I need this done tomorrow and I cannot wait for the parts to come in.
Hi guys so I’ve been tackling my ball joints today, and they were a pain in the ass to remove and so far have been a nightmare to reinstall. I was able to put the bottom in with no issues, I cannot figure out a way to get the angle correct to reinstall the top one. My problem is arising at the...
I am going to be using Dana 44’s but I’m getting them from a buddy and they are fully built. He was supposed to already have his new axles but something happened so taking possession of them has been put on hold until the end of August. I wouldn’t waste my time but I’ll be towing my boat and...
Hey guys, so I have decided to go ahead and pull the trigger on replacing the garbage rear drums on my XJ, I have heard that the KJ swap is a direct bolt on swap, so I figured this would be the way to go. What I am wondering is what all I need to complete this swap. I’ll list what I think I’ll...