Search results

you said that you were going to do the 30 spline chromo shafts on this build and I had herd that when you do this you still have the weak link at the outer 27 spline shaft and it makes it harder to find a replacement on the trail if you do happen to break a inner shaft. Has anyone had this...

I Have recently purchased a used HP dana 30 to replace my LP dana 30 in my 2000 cherokee. I have about $3000 to put rebuild the HP with 4.56's 30 spline chromos an ox locker and a fully mounted TNT truss which will prob. not be within that budget. Today i was looking at some of the axle kits on...

Thanks for the help. I'll dig a little deeper.

I recently came across a HP dana 30 for $100 so I bought it as a project for the next cople months. I want to put the WJ outers on it but I cant find very much info on the swap. I know that I will have to change one of the ball joints to a WJ ball joint but other than that is it a direct bolt...

Does anyone know if OX makes a locker for a chrysler 8.25 I have looked online and did not see one.

fi the axles are still available i will buy them. i'll send you a pm

this is a front dana 44 my concern is that the perches are cast to the housing

So I found this dana 44 out of what the seller says is a 1986 wagoneer. It looks good but the only question that I have is why in the sticky that crash posted does it only list the years 1980-84 as the 44's that will work in the xj. I want to move on this fast so any advice or coments would be...

Im still getting into the off road/rock crawling and I dont want to have to upgrade all my steering components. is going to a dana 60 up front going to require all the upgrades. I just want a solid bace for my 4.56's detroit and 33"X 12.50's. I didn't want to waste any money in a low pinion dana 30

In my endless search for a replacement for my low pinion dana 30 front I have somehow come to the conclusoin that I should be able to chop a full width dana 60 out of a 3/4 ton ford. Granted I have littlt fabrication experience but am hoping that I can get by with access to good halp and a...

I have a similar question, I have a lpd30 that I want to put 4.56 gears and an aussie locker in but I have plans for a hpd30 in the near future. can I use the same set up in the hpd30?

Im looking at 3 dana 44's on craigs list and i'm trying to figure out which would be the easiest to put under my 2000 xj. I dont have a whole lot of fabrication experience but I have the resources to get the job done. here are the choices of host 44 vehicles. 1) 72 blaser 2)78 dodge 3) unknown...

Eventually I replaced my whole coolant system(hoses, t'stat and housing,water pump, radiator) because of this same issue. when I did the swap out I flushed the heater core and the block several times onder pressure with a water hose and got most of it out but now two weeks down the road it is...

Im currently prepairing to swap out my old radiator for a new 3 core and im trying to track down all the hoses used by the cooling system so i can replace them due to the deteriation of the old lines. I also decided to upgrade the whole cooling system by adding a high flow: hesco water pump...

My 2000xj is leaking refrigerant from the passinger side floorboard and im thinking that it is the evaporator core. I have one of the haynes manuals to refer to but it dosn't tell you anything about the evaporator core. after researching the work involved in installing a heater core I was...