Search results

Please let me know if you can help me out. Need bezels and trim for single rectangular headlights also. TIA Bill-93XJ

4 wheels down? 93 XJ. AW4 tranny TIA Bill-93XJ

My 93 XJ was giving typical CPS symptoms. Changed it out. Ran OK for a while. Then the fuel pump was working intermittently. Found a green wire with a black tracer that comes from O2 sensor circuit and enables the fuel pump relay to energize. The connector was a piece of crap and it was not...

Well, I thought I had it under control.... famous last words.... My '93 4.0L 6cyl w/ AW4 is all bone stock. I had experienced it running rich and sputtering a bit lately. I have 153,000 on the clock and this baby has been taken care of pretty well. Never abused. I have changed fluids...

I had this happen a few years back and swapped in a new CPS and it cleared up. Driving along, ignition stumbles and dies. Bring her to a stop and cranks up OK, drive a little bit and it happens again. It's like the spark just decides to take a vacation for a little bit. This weekend I put in...

Hey guys, Does anyone know of a better deal than this: http://216.71.117.16/catalog/page151.html WTF is this part so high priced anyway? I am still on my factory switch which was new in 1993. Took it apart and cleaned it once, but the reverse lights quit working a while back... time to...

I measure 1.3 OHMS...... is it good? 93 XJ 4.0L Please check out related post: http://www.naxja.org/forum/showthread.php?t=916565 TIA Bill-93XJ

Yes, I did a search.... 'fuel pump voltage' could not find this answer. My '93 had the in-tank fuel pump replaced June-2002 (by me). Now the pump does not run. The part in there now is a NAPA Balkamp (Carter) and it has run flawlessly for nearly 4 years. All of a sudden, with key on there...

1993 4.0 L with AC and all the power accesories. Serpentine Belt. The mondo bracket that holds the a/c compressor also has a spindle that supports the fan and fan clutch. In mine, the spindle has started to wear and it is now metal-on-metal grinding. Is this a press fit bushing? Bearings? I...

My XJ is 93 with Tan interior. Seatbelts by Bendix. Crapola. Driver's side front failed open. Pass side front just failed closed. My question is will a 'newer' style female end (newer type has red button?) work with the old parts? What year did they switch to the new style? TIA.... Bill-93XJ

Or Equivalent. Please PM me thanks, Bill-93XJ

I have had another incident with the female latch mechanism on the factory original seat belts in my 1993 XJ. The first incident was when the internal spring on the driver's side broke. Last week the passenger side failed closed with my wife buckeled in. (She was able to extract herself by...

1993 XJ and I am getting ready to lift it 3". I just wondered how to go about ordering the right HI-JACKERS (I mean they gotta be 3" longer than stock, right ??) Do these shocks ride rougher than hydraulic shocks ?? Wear out quicker ?? I would love to hear you guys experience....... TIA...

Anyone know how to reset the maint required light on a '92 XJ 4.0L? (asking for a friend..... my XY is 1993) TIA, Bill-93XJ

Are they the same ?? Same spline ?? Would SYE flange from 231 work on a 242 ?? TIA..... Bill-93XJ

Hey guys. Will one of the newer 1998 and Up? rubber windshield gaskets retrofit into my 1993 ?? I have the chrome plastic trim molding and I am tired of the wind noise. I am looking at new glass anyway and was wondering aout the rubber ring gasket. TIA..... Bill-93XJ

Hey fellow Jeepers.... I have been away for quite a while and now I come back to dive the depths of your collective knowledge.... Well, I knew that my PS pump has been going bad for a while because of the noises. Then I noticed a wetness on side of the air cleaner box. It seems that the hose...

I need advice..... I just bought new rear leafs which are 2.5 inches taller and ZJ coils which are supposed to be 3.0 inches higher for the front. Add to that some BB parts (1.5 inch blocks for rear and the 1.5 inch coil spacers for front) and I should be at 4 to 4.5 inches lift. My rig is...

1993 Cherokee Country. Looking for front coil springs 3"-4" over stock. TIA, Bill-93XJ

Hey fellas, my knowledge of the electonics on the engine controls is pretty weak. If I wanted to tweak the ignition timing (advance it) a degree or two, how would I do that on my 93 Country? Slot the CPS holes and rock the unit to one side? I was toying with the idea of tryin the mod on...